Xiaomi 4 Lite Gen2 rear light replaces the scooter rear lighting unit. It has an elongated red lens, a black housing with two mounting tabs and an approximately 71.5 cm cable ending in a white two-pin connector. This is an original replacement part.

Xiaomi 4 Lite Gen2 rear light with long cable

The cable is already connected to the light housing. Route it to the scooter wiring connection, following the intended path beside the rear mudguard and wheel. The two fixing points secure the unit at its matching mounting position.

• Compatibility: Xiaomi 4 Lite 2nd Gen electric scooter.
• Type: rear light with connection cable.
• Lens colour: red.
• Light width: approximately 80 mm.
• Mounting hole centre spacing: approximately 48 mm.
• Cable length: approximately 71.5 cm.
• Connector: white, 2 pins.
• Package: 1 light with cable.

Compare the housing and mounting points

Check the light shape, mounting tab positions and cable connector against the original unit. This is an elongated version, distinct from the round rear lights used on some other Xiaomi models. The 48 mm fixing centres must match the existing mounting base.

Cable routing and operation check

Keep the cable clear of the rotating tyre and do not trap it under the fixings. Before connecting, compare the shape of the white plug, its contacts and the wire positions.

After securing the unit, switch on the scooter and check rear light operation. If it remains unlit, check the incoming supply and the condition of the wiring too. The mudguard and its other components are separate from this light assembly.